See the red yellow blue green basic indicator on the instrument panel

●   The meaning of the color of the truck dashboard light

  Depending on the driving situation, there will be different colored lights on the instrument panel. In general, colors have the following meanings:

  The red indicator light, which is generally a driving warning light, serves as a warning for serious malfunctions while driving. Fatal or major personal injury accidents and serious damage to the vehicle or other major property damage. Take appropriate response immediately.

The yellow indicator light, which is generally a driving warning light, serves as a warning for general faults that occur during driving. Serious problems can cause damage to the vehicle. Correct the fault as soon as possible. Other measures: Pay special attention to whether the enabled features work properly.

The blue and green lights are general driving lights. Information from normal operating features.

●   Indicator light on truck dashboard

  Two-color indicator

Look at the red, yellow, blue and green indicators on the dashboard.

Red is a warning stop indicator and alarms when there is a serious fault.

Yellow is a public alarm and is normally alarmed when a fault occurs.

  Red light

Look at the red, yellow, blue and green indicators on the dashboard.

Engine oil pressure indicator, alarm when oil pressure is low. The indicator lights up when the ignition switch is turned ON, but it goes out after the engine starts. If the indicator is still on when the engine is running, you should turn off immediately and contact your nearest dealer.

Parking brake indicator, manual brake valve handle when pulled down. When the ignition switch is turned on and the parking brake is not released, the parking brake indicator will light. When the parking brake is released, the parking brake indicator will be extinguished. The car can only be started when the parking brake is released and the parking brake indicator has gone out.

Charging indicator, the generator goes out after generating electricity. When the ignition key is turned on, the charging indicator light should be on. When the engine is running, the charging indicator will go out. If the charge indicator is still on while you are driving, you should stop and turn off the engine to check the tensioner belt. If the belt is loose or worn, it should be adjusted or replaced.

Seat belt lock indicator, after the seat belt is fastened out. When the ignition is turned on, the seatbelt indicator flashes for approximately 5 seconds to remind the driver to wear the seat belt. If the driver wears the seat belt within 5 seconds, the indicator will go out. When the ignition switch hits the ACC or LOCK position, the indicator will also go out.

Look at the red, yellow, blue and green indicators on the dashboard.

Water temperature indicator, alarm when the water temperature is too high. If the temperature of the coolant is too high, the indicator lights up. If the coolant is low, the alarm buzzer will also beep at the same time. At this time, the car should be driven to the side of the road, stop and check the position of the liquid level of the coolant. If necessary, coolant can be added, and it can be added between the minimum level of the level marking line and the highest level.

Brake pressure indicator, brake pressure low pressure alarm. Brake fault warning light, when the braking system is leaking or the performance of the brake shoe wears down, the brake failure warning light will be on. If possible, stop to contact the dealer immediately.

Auxiliary gas indicator, auxiliary gas circuit alarm when low pressure.

Look at the red, yellow, blue and green indicators on the dashboard.

The door status indicator shows whether the door is fully closed. When the door is opened or fails to close, the corresponding indicator lights up, indicating that the owner's door is not closed and the door is closed and then extinguished. Note: Close the door when driving. Before driving, check whether the door warning light is off.

Look at the red, yellow, blue and green indicators on the dashboard.

When the cab lock light is off and the lock hook is not locked, the light will be on.

  Yellow light

Look at the red, yellow, blue and green indicators on the dashboard.

Fuel low indicator. When the yellow indicator light is on, it prompts you to refuel.

The engine warm-up indicator, in the cold season, if the ignition switch is turned ON, the light is on, and the switch should be kept in this position until the light is off. Wait until the light goes out and turn the switch to the START position to start the vehicle.

Look at the red, yellow, blue and green indicators on the dashboard.

The exhaust brake indicator is an indication of the engine's exhaust brake operation. When the exhaust assist brake switch is turned on, the indicator will light; reset the switch and the indicator will turn off.

Rear fog lamp indicator, rear fog lamp work instructions.

ABS brake anti-lock trailer light, main vehicle ABS fault indication.

Look at the red, yellow, blue and green indicators on the dashboard.

Inter-axis differential lock indicator, axis difference work instructions.

 Look at the red, yellow, blue and green indicators on the dashboard.

The indicator light of the cleaning liquid shows the indicator of the amount of the windshield cleaning fluid. If the cleaning fluid is about to run out, the light is on, prompting the owner to add the cleaning fluid in time. After the cleaning fluid is added, the indicator goes out.

TCS indicator, this indicator is used to display the working status of the vehicle TCS (Traction Control System), mostly appear on the Japanese car. When this indicator is on, it indicates that the TCS system has been turned off.

Look at the red, yellow, blue and green indicators on the dashboard.

●   Blue light

Look at the red, yellow, blue and green indicators on the dashboard.

High beam indicator, high beam work instructions. As long as the headlight switch hits high beam, the high beam indicator will light.

●   Green indicator

Look at the red, yellow, blue and green indicators on the dashboard.

Front fog lamp indicator, front fog lamp work instructions.

Trailer indicator light flashes green. With a trailer, the left or right turn indicator flashes at the same time.

Turn indicator, a green flashing arrow on the instrument panel indicates the turning direction of the turn signal indicator. If the arrow is bright but not flashing, it may be that the turn signal is faster than normal or does not flash at all. In this case, check the turn signal system for malfunction.

Look at the red, yellow, blue and green indicators on the dashboard.

Inter-differential lock light indicator, wheel difference work instructions.

The rear work light indicator is mostly on the tractor. When the rear work light switch is on, the indicator light is on. Turn off the switch after completing work or when driving normally.

Look at the red, yellow, blue and green indicators on the dashboard.

Of course, the lights on the dashboard of the truck are not only these, it may be more than a hundred, if everyone knows what is welcome to add.

DFA Light Truck Spare Parts

DFA Light Truck Spare Parts,DFA Truck Spare Parts,DFA Truck Spares,DFA Light Truck Spares

Jinane Baisheng International Trade Co.,Ltd , https://www.jnbisontruck.com