The main structure of the multi-function greening sprayer: 1 PTO 2 Water pump 3 Water tank 4 Communication valve 5 Fire ball valve 6 Filter 7 Front punch valve 8 Sprinkler valve 9 Side spray valve 10 Rear spray valve 11 Sprinkler 12 Can lid 13 Prompt 14 side spray Lotus head 15 after Sprinkle 16 anti-rotation plate ABC, three-way four-valve
First, add water
1. Open the car to a predetermined position so that the mouth of the tank is aligned with the tap of the tap. Open the cap and tap water to add water.
2. When the water is collected in the field, water can supply water to the tank through the water pump. Its operating procedure is: connecting a rubber hose to the surface water source at the four-position three-way valve A to make the three-way ball valve A and C communicate, closing the ball valve 7, 8, 9, 10, opening 4, and stepping on the clutch to open the power. Switch, slowly release the clutch (do not be too fast, otherwise it will damage the power take off or gearbox), so that the water pump starts working, you can add water to the tank, stop the switch back to work.
Second, sprinkle water
Connect the c and b of the three-way and four-position valve, close the valve 4, open 7, 8, 9, 10 as needed, where 7 is the forward punch switch for flushing the road and 8 is the water gun switch (can be used for emergency fire fighting. Long-distance watering of flowers and trees). 9 is a side spray switch, which can water the roadside flowers and plants. 10 is a post-sprinkler switch for watering the pavement.
After the water in the water tank is sprinkled, separate the clutch and remove the power take-off device.
Third, watering flowers, emergency fire
Turn on the three-way and four-position ball valves, B and C are connected, 4, 7, 8, 9 and 10 are closed, and then a hose is connected at 5, and the other end of the hose is connected to a water gun. Using the gravity of the water, the water can be flowed freely. . Can also be hung on the power take-off pressure emergency fire or long-distance watering flowers and trees.
IV. Active pump station
Turn on the three-way four-valve A and C. Connect the suction hose to the A port, close the 4, 7, 8, 9, and 10, open the valve 5, and take out the water pipe at port 5 so that the water pump can start working. The pumping of the ground to the second floor serves as an active pumping station.
The SDRFL Cast Version Inline Hydraulic Filter is designed according to international regulations. It consists of a two piece Filter Housing with a bolt-on cover plate. Inlet and outlet positioned at the same side or opposite side.
| Filter Element |
Filter elements are validated according to ISO test standard, with the following pressure stability values:
BN/HC: 25 bar P/HC: 10 bar
Wire mesh( W/HC ): 30 bar V: 30 bar
Compatibility
It can be used for mineral oils, lubrication oils, non-flame fluids, synthetic and rapidly biodegradable fluids.
For water or other application, please contact us.
Crane Filter,Machine Filter,Cast Version Filter,Stainless Steel Cast Version Filter
Xinxiang Shengda Filtration Technique Co., Ltd. , https://www.filtrations.nl